Ubuntu avg update
This should get you Version 30.43 with date make.
#Ubuntu avg update code#
If you get the DSP binary code or ".out" file (or not really firmware, that would be a different level, but not to worry about.) from here (current ls -l *out Even I am not sure why it misbehaved before, it should just complain about the old DSP code as it did now. You may check via the Patch-Rack (mk3-spm-configurator.py script) what is the actual input for ANALOG_AVG_INPUT.Īlso check via the Siganl Monitor the actual reading of the AVG Siganl and if it matches it's input. I temporary used the mixer channel, those have a different internal scaling with respect to 32bit (+/-15.16 bits for In0) and (+/-23.8 bits for MIX0.3) signals as there room for computation is needed - all fixed point - thus you may see a factor of 256 if you use a mixer channel and do not correct for it.Ĭ) The actual signal definition (dsp_signal.h) - normally no need for adjustments. The obvious default is "In0" and not eventually MIX0. There are a few configurations effecting the "PanView Reading for "nA":Ī) The Gxsm Preferences (Instrument/nAmpere2Volt = 1.0 for no gain with repect of Volts to "nA")ī) With the introduction of the Signal Master now the Signal to be used must be configured as RMS/AVG Module input. The live DVD and ppa's are always a little behind. Hi! Sorry for the inconveniences.There have been a lot of developments recently.Ĭurrent it Gxsm 3.10 Signal Master Evolved (out of SVN).